Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Repair in North Richland Hills, TX
Gate access control in North Richland Hills mostly means updating keypads, intercoms, and remotes on gates that were installed when the house was built, which for most of this city means somewhere between 1978 and 1998. The original wiring is now 30 to 45 years old, and the Blackland Prairie clay that shifts under every post in this area also stresses the low-voltage lines that run alongside them. If your keypad works intermittently or your remote only opens the gate from ten feet away, call (817) 826-9477 and we’ll diagnose it with documentation, not guesswork.
Why North Richland Hills Homes Are Different
North Richland Hills is fully built out. Unlike Keller or Southlake where new construction keeps installers busy, NRH work is almost entirely repair and replacement on aged infrastructure. The homes around Fossil Creek, Smithfield, and the neighborhoods off Rufe Snow Drive were built in a window when 6-foot board-on-board cedar was the default privacy fence, and the matching drive gates were installed as part of the original construction. Those gates are now decades past their intended lifespan.
The soil here is the bigger problem. Blackland Prairie clay swells after spring rains and shrinks during summer drought, and that cycle shifts gate posts out of plumb year after year. A gate that latched perfectly in April can bind at the latch in August. Add North Texas hail and the severe thunderstorm season, and aging cedar boards crack or blow out entirely. Technicians working North Richland Hills keep extra pickets, hinges, and control boards stocked through April and May because storm-season calls are predictable here.
Our Main North Richland Hills Services
Most calls from North Richland Hills fall into two categories: repairing what time and clay have done to an existing gate, or replacing it after a storm or post failure. These are the three service pages specific to this city.
Gate Repair in North Richland Hills
Repair here usually means resetting a post that the clay has shifted, reskinning a gate after hail damage, or fixing a latch that no longer lines up. We photograph the post base, measure the offset, and hand you a written price before any tool comes off the truck. That’s the standard on every job in North Richland Hills. Full scope, local pricing, and signs to call are on the Gate Repair in North Richland Hills page.
Gate Installation in North Richland Hills
When a gate is beyond repair, or an HOA in an NRH subdivision specifies a matching board-on-board replacement, installation is the answer. We work within the material and stain requirements that established NRH neighborhoods enforce, and we document every measurement and post depth before concrete goes in. See Gate Installation in North Richland Hills for what a full replacement includes and what it costs here.
Gate Motor & Opener in North Richland Hills
Older NRH gates often got their first opener installed long after construction, and the wiring runs are improvised. When a motor fails, we check the whole circuit before recommending a replacement, and we service nine major automation brands rather than pushing one. Pricing for motor replacement and opener repair in this city is on Gate Motor & Opener in North Richland Hills.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
BeforeAfterGate Access Control in North Richland Hills
Gate access control in North Richland Hills usually means the keypad, intercom, or remote system that tells an older gate motor what to do. Homes built between the late 1970s and mid-1990s here often have original low-voltage wiring that’s been patched, spliced, and stressed by the same clay movement that shifts the posts. Our Gate Access Control work starts with tracing that wiring and documenting what’s actually there before we recommend replacing anything.
Keypad Entry
Signs you need it
Keys work sometimes, the keypad only responds when you press hard, or certain codes stopped working after a storm.
What it costs in North Richland Hills
Keypad replacement or reprogramming in North Richland Hills typically runs $150 to $450 depending on whether we’re repairing wiring or installing a new weather-sealed unit.
How we do it
We test the circuit at the keypad, check for corrosion from North Texas humidity, replace or reprogram the unit, and photograph the finished install with the new code set.
Phone Entry
Signs you need it
Visitors can’t reach you through the gate, the phone line buzzes, or the system opens the gate for every caller regardless of the code.
What it costs in North Richland Hills
Phone entry system service in NRH runs $350 to $900 for hardware and programming, more if we’re pulling new cable to the house.
How we do it
We verify the line, test the relay at the gate operator, replace or reconfigure the phone entry board, and leave a written record of every programming change.
What Gate Access Control Costs in North Richland Hills
| Item | Typical range in North Richland Hills |
|---|---|
| Keypad replacement | $150 - $450 |
| Phone entry system | $350 - $900 |
| Video intercom | $600 - $1,800 |
Can you upgrade my old keypad without rewiring the whole gate?
Often yes. Many NRH gates have serviceable low-voltage runs, and we can install a modern weather-sealed keypad on the existing wire if it tests clean. Call (817) 826-9477 with photos and we’ll tell you what’s feasible before scheduling.
Does access control work on any gate opener brand?
We service LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule, so the access control gets matched to whatever motor you already have. We don’t push a replacement just because it’s an older unit.
Gate Parts & Welding in North Richland Hills
Gate parts and welding in North Richland Hills usually means restoring a 30-to-40-year-old gate that’s sagging at the post, blown out at the hinge, or cracked at a weld from years of clay movement. Homes here were built with cedar gates on steel frames, and both materials have a lifespan. Our Gate Parts & Welding work replaces what failed and leaves documentation of every part number and weld position.
Hinge Replacement
Signs you need it
The gate drags at the latch side, the hinge pin is visibly worn, or the gate sits lower than it did last year.
What it costs in North Richland Hills
Hinge replacement in NRH runs $120 to $350 per hinge, including realignment and a photographed finished position.
How we do it
We support the gate, remove the failed hinge, verify the post is still plumb, install a heavier-gauge hinge, and set the gate to clear by at least an inch at the latch.
Post Replacement
Signs you need it
The post leans, the gate binds at the top of the latch, or you can see a crack at the base from freeze-thaw cycles.
What it costs in North Richland Hills
Post replacement in this city runs $350 to $900 depending on depth, concrete footing, and whether the gate has to be resquared.
How we do it
We dig out the old post, set a new one below the frost line and past the active clay zone, brace it square, and concrete it in place with photographic documentation.
Custom Welding
Signs you need it
A steel frame has cracked at a joint, a hinge plate tore loose, or a storm bent a section past straightening.
What it costs in North Richland Hills
Custom welding on gate frames in NRH runs $200 to $600 for a typical repair, more if we’re fabricating a missing section from scratch.
How we do it
We grind the failed joint clean, weld with the gate clamped square, paint or coat the repair, and record the welder settings in your job file.
What Gate Parts & Welding Costs in North Richland Hills
| Item | Typical range in North Richland Hills |
|---|---|
| Hinge replacement | $120 - $350 per hinge |
| Post replacement | $350 - $900 |
| Custom welding | $200 - $600 |
Can you match the cedar my HOA requires?
Yes. We carry cedar pickets and match stain or paint to the written HOA standard before we touch the gate. Bring the HOA document to the estimate and we’ll note every requirement in the written scope.
Do you weld on-site or take the gate to a shop?
Both. Small repairs happen on-site in your driveway. A badly deformed frame may go to our fabrication bench so we can clamp it square, but either way you get a written price before we start and a photo record when we finish.
Brands We Service in North Richland Hills
We service Viking, Ghost Controls, and DoorKing operators regularly in North Richland Hills, along with six other major automation brands. Common replacement parts for these units are stocked on our trucks, which shortens most motor repairs here to a single visit. See our brands for the full list and what we keep locally.
Pricing for Gate Repair in North Richland Hills, TX
| Service | Typical range in North Richland Hills |
|---|---|
| Keypad replacement | $150 - $450 |
| Phone entry system | $350 - $900 |
| Video intercom | $600 - $1,800 |
| Hinge replacement | $120 - $350 per hinge |
| Post replacement | $350 - $900 |
| Custom welding | $200 - $600 |
| Gate roller replacement | $180 - $400 |
| Rail repair | $220 - $500 |
Prices in North Richland Hills get pushed up by deep clay that requires longer post footings, HOA material requirements that limit what we can install, and storm-season demand that affects parts availability in spring. What they never affect is our price policy: you get a written number before any work starts, and that number doesn’t change at invoicing.
Neighborhoods We Serve in North Richland Hills
We run calls across all of North Richland Hills, including the older subdivisions where gate failures cluster. Response time for most repair calls in this area is same-day or next-day, and emergency storm response in April and May is prioritized by how badly the gate is down.
- Fossil Creek
- Smithfield
- Home Town North
- North Park
- Walker’s Creek
Service Area - Cities Near North Richland Hills
Vance Gate Repair also serves the cities immediately around North Richland Hills. If you’re in Hurst, TX, Bedford, TX, Colleyville, TX, or Keller, TX, we run the same routes with the same written-price policy and same documentation. Dispatch is coordinated from our Dallas-Fort Worth office; crews serving North Richland Hills are local to the area.
Serving North Richland Hills, TX - Our Local Coverage Area
We’re based in the North Richland Hills area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Repair in North Richland Hills
Same-day for most failures, and we prioritize storm-season calls in April and May when falling limbs from mature post oaks take out gates overnight. Call (817) 826-9477 and a live person answers, no voicemail queue.
For repairs, usually not. For replacement, many NRH HOAs require approval on materials and finish. We work from your HOA’s written standard and can note every requirement in the written scope before we order anything.
Both. We diagnose the whole system, from post to hinge to motor to keypad, because a gate that’s binding at the latch can burn out an opener motor in North Richland Hills’ clay soil conditions. The written diagnostic covers everything we checked.
If your gate is sagging, binding, or refusing to open in North Richland Hills, call (817) 826-9477 for a free estimate. We’ll hand you a written price before any work begins, and we’ll leave you with a photo record of everything we found and fixed.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What North Richland Hills Customers Say
"The safety loop had never been installed correctly by the previous company. They showed me the reading, fixed it, and did not charge me for the diagnosis."
- Patrick H."Honest about what did not need doing. Told me the operator had years left and only the control board needed replacing."
- Douglas N."Gate had been dragging for a year. They photographed the bent hinge post, explained why the operator kept faulting, and gave me a fixed price to correct both."
- Terrence B.